Electrosurgical Units

OUTPUT WAVE FORMS
BLEND 1: 510 KHZ sinusoisal bursts at 50% duty  cycle recurring at 31 KHZ
BLEND 2: 510 KHZ sinusoisal bursts at 37.5% duty  cycle recurring at 31 KHZ
BLEND 3: 510 KHZ sinusoisal bursts at 25% duty  cycle recurring at 31 KHZ
COAG: 510 damped sinusoisal bursts  with a repetition frequency of 31 KHZ
LOW VOLTAGE COAG: 510 KHZ sinusoisal bursts at 25% duty  cycle recurring at 31 KHZ
BIPOLAR: 510 KHZ sinusoid less than 5% or 5 watts, whichever is greater, as the line voltage varies from 85-135 volts(into a 300 OHM load).

 

LOW FREQUENCY LEAKAGE (50-60 HZ)
Source current, patient leads, all outputs tied together.

Normal polarity, intact chassis ground <10 µA

Normal polarity, ground open<100 µA

Reverse polarity, ground open <100 µA

Sink current, 140V, applied, all inputs <150 µA

HIGH FREQUENCY LEAKAGE
Less than 150 MA RMS

INPUT POWER REQUIREMENTS
Operating range is 85 to 135 AC volts. Current is less than 8

amperes in cut and less than 4 amperes in coag.

POWER READOUTS
 Agree with actual power into rated load within ± 15% or  5 watts, whichever is greater.
ADAPTIVE REM™ SYSTEM
MEASUREMENT FREQUENCY: 140 KHZ ± 20 KHZ
MEASUREMENT CURRENT: 3 MA max
ACCEPTABLE RESISTANCE RANGES:
        REM™ PAD - 5-135 OHMS
        NON-REM™ PAD - less than OHMS

Acceptance range is 5-135 OHMS after Rem™ Polyhesive™ II

return electrode is applies. Rem™ trip is initial impedance plus

40%. For example, if the initial impedance is 30 OHMS, the upper

level trip is approximately 42 OHMS.

 

COOLING
Convection, no fan

The mode indicator tones are adjustable to a minimum level of 45

db at 1 meter. The alarm tones are not adjustable and are set at

65 DB minimum at 1 meter

 

 
Also available is 220-240-volt, 50-60 hz configurations